Second address is technically incorrect. The loopback address subnet 127/8 does not contain private network addresses like 192.168/16, 172.16/12, or 10/8 and doesn’t provide any utility for routing within the local network.

I use Altium Designer and KiCAD. KiCAD isn’t as good by just a hair but makes up for it by being free and open-source. Altium Designer is also crazy expensive for hobbyists.

Yes you can absolutely breadboard it. Forcing a current is as easy as following ohm’s law. Make sure there is a certain voltage across a resistor and ensure that only a negligible amount of that current is leaked elsewhere. A difference amplifier is a good way to ensure this, as long as you pay attention to the amplifier input currents.

If current regulation isn’t super important, a highish voltage (say 24+ V) and a large resistor will also work because the variation of threshold voltage will be so small that the voltage across the resistor will be relatively stable.

I think there is some confusion about the word diode here. The transistor is effectively an inverting amplifier, that is that the drain voltage is reduced if the gate voltage is increased. By tying them together, they reach a stable configuration where the gate is just high enough to make the drain low enough for them to be equal. In this configuration, there are two terminals, hence the di in diode. Like a traditional diode, it has a very nonlinear voltage-current relationship. If you apply 10V to it, theoretically the current would be thousands of amperes. Practically that won’t happen but you will blow up the transistor.

I don’t know enough about radiation and semiconductor physics to answer your other questions but if I were you I would just build it and test it. MOSFETs and resistors are cheap and if you do have a radiating source on hand it might be easier to try and fail than to hope someone here can tell you what your part will do when exposed to conditions outside of the manufacturer recommendations.

I used to comment quite a bit on reddit, but that was usually to get into technical discussions or political arguments. So far there hasn’t been much technical content for me to sink my teeth into and I have yet to run into posts or comments calling for my extermination so I haven’t felt compelled to say anything. I’m glad that people here are nice, but I miss answering questions about electric circuits, embedded systems, etc.

Here’s hoping that some day soon when people can’t figure out why their op-amp is driven into saturation they don’t post about it on reddit first.