When I came into my office this morning, I found that my boss moved his resin printer into my office and the setup reeks of solvent (it smells like a hundred uncapped expos). Are these fumes fine? Or am I gonna end up with half a melted brain by the end of the week?

  • llamapants@lemmy.world
    link
    fedilink
    English
    arrow-up
    18
    arrow-down
    1
    ·
    edit-2
    11 months ago

    From my very limited knowledge in 3D printing and the types of solvents used, most contain things like acrolein and acetone, both of which are known toxins. So yes, this is a health risk without proper ventilation and I’m guessing your office doesn’t have that. I’d bring this up immediately with your boss and if you have the original containers the solvents came in, check for ingredients and potential health hazards.

    • Bipta@kbin.social
      link
      fedilink
      arrow-up
      8
      ·
      11 months ago

      Acetone is not considered to be a carcinogen or even promoter of existing cancers. To my knowledge, no reputable source claims otherwise.

      • bluGill@kbin.social
        link
        fedilink
        arrow-up
        5
        ·
        11 months ago

        Right, but there are plenty of other fumes from resin printers which might be harmful. Without knowing which resin, and reading the SDS for it we can only speculate on what might be there.

      • llamapants@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        ·
        11 months ago

        I corrected it to toxins, as acetone can still be harmful. Thanks for bringing it to my attention.

      • psud@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        11 months ago

        We’d see a lot of finger cancers if it was. Acetone being the primary solvent in nail polish remover